It’s easy to use pine. I’ll do a little expansion on how to choose pine. It’s as follows:
Pine because woodiness is loose, grease is more have smell, not be the good choice that makes furniture actually. But it’s cheap.
The children furniture on market still is the world of pine basically, other furniture also uses pine in large numbers as auxiliary material, but although it is pine, quality also varies thousands of times, the price also differs in more than one times. Although woodiness does not calculate excellent, but after calculate on cheap, pine wood had very high cost performance. In fact, we do not need to be camphor pine, Korean pine, radiate pine, New Zealand pine, Finland pine these are not in the same dimension of the name dizzy, we may be very simple from a few points to judge a piece of pine furniture material level.
1.First, look at the scar, a good piece of pine furniture should be completely without any scar.
Without scar means that the diameter of the tree is big, branches are less, such products mainly are the radiative pine of New Zealand and the Korean pine of Finland, this also is the best quality in pine, the price is the most expensive two kinds, the selective material standard that explains the manufacturer is high. At the same time, the oil of pine will be enriched in the scar, the more pine scar, generally speaking, the greater the taste.
2.Second, look at the color. The lighter the color, the better.
The New Zealand pine is very light in color, and the Finnish pine, although classified as red pine, is actually a very clean light color, quite different from the cloudy yellow of the other more oily pine. Pine of this kind of light color, general taste is smaller, material material is relatively more delicate.
3.Third, look at the texture. The straighter the texture, the better.
Pursuit with other furniture mountain pattern is different, pine grain is more straight show character is better. Texture is straight on the one hand, shows good dry form, branches and less scar a youthful appearance, if the pattern are all basically parallel straight lines at the same time, it is likely still USES the diameter of the cutting board, this is a very rare wood cutting, generally only used in large diameter, dry form good wood, the loss is high, but the sawn timber material evenly, The chance of cracking and deforming is much lower than that of a normal chordboard.
When choosing children’s furniture, we may be most concerned about the problem of pollution. If we not only limit the topic to pine furniture, are there any processes or materials that can reduce the pollution release of children’s furniture? What are the advantages of them compared with pine wood?
The pollution of solid wood furniture mainly comes from the surface coating, and then the woodworking glue and natural wood itself. So to reduce the pollution, we should start from these three aspects – cancel the coating as the biggest source of pollution, use less woodworking glue and use the best woodworking glue as far as possible, and choose wood with low formaldehyde content.
Getting rid of the paint is easy to say, but you have to deal with a whole bunch of problems:
1.Paint can hide blemishes, the removal of paint means the need for a higher level of material selection, the natural material itself to show the appearance.
2.Coating can close the surface and reduce the risk of cracking and deformation. If the coating is cancelled, efforts must be made in all aspects of expansion margin and structural design to offset the consequences of humidity deformation.
3.Coating can improve the feel, so only choose their own material is delicate enough wood, plus high specification grinding to a certain extent to make up for.
4.Coating can also be antifouling, this can not be done, can only rely on the choice of not too light and not too dark wood, but the bedroom environment is relatively dry and clean.
Post time: Jun-30-2021